[U-Boot-Users] mtest

[himbA <goavr@email.si>]

Wolfgang Denk wrote:
> In message <406D56A5.2090102@email.si> you wrote:
> 
>>at bootup uboot displays
>>U-Boot code: A3F00000 -> A3F177B8  BSS: -> A3F1BAD8
>>
>>Is there some uboot relevant stuff between 
>>0xa3efffff - 0xa3dfffff that I run over when doing 
>>mtest on all 63Mb? Code and stack seem to be safe.
> 
> 
> What do you think where the stack and the malloc  arena  is  in  your
> configuration?
> 

I thought code starts at _TEXT_BASE (0xA3F00000) 
and stack is from  0xA3F177B8 to 0xA3F1BAD8 
(u-boot header display suggested so). Your 
question was in place and I checked the start.S 
once again to find out that after reset and 
relocate we setup stack below _TEXT_BASE and not 
above. I corrected the CFG_MEMTEST_END to be just 
below malloc and stack.

  Thanks!

regards, himba

-- 
..because under Linux "if something is possible in 
principle,
then it is already implemented or somebody is 
working on it".
							--LKI