From mboxrd@z Thu Jan 1 00:00:00 1970 From: Robin Gilks Date: Thu, 23 Sep 2004 09:41:13 +1200 Subject: [U-Boot-Users] Netconsole at startup Message-ID: <4151F179.40100@tait.co.nz> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Greetings Bit of a puzzle with netconsole operation. If I undef CFG_CONSOLE_IS_IN_ENV, then I can boot to the serial console and manually switch it to nc and it works great. Problem with that is that on boot it just uses the first device that has the correct in/out properties - i.e. serial and ignores any env setting. If I define CFG_CONSOLE_IS_IN_ENV, then the netconsole stuff refuses to run (i.e. it doesn't use serial but it doesn't use nc either!!) - even though when checking with the BDI2000 I can see that the correct nc devices have been set up in the dev structures. If I start up in serial and then try to switch to nc it just doesn't work - it continues to use serial. Any clues from anyone? Should netconsole be able to run from bootup? -- Robin Gilks Senior Design Engineer Phone: (+64)(3) 357 1569 Tait Electronics Fax : (+64)(3) 359 4632 PO Box 1645 Christchurch Email : robin.gilks at tait.co.nz New Zealand ======================================================================= This email, including any attachments, is only for the intended addressee. It is subject to copyright, is confidential and may be the subject of legal or other privilege, none of which is waived or lost by reason of this transmission. If the receiver is not the intended addressee, please accept our apologies, notify us by return, delete all copies and perform no other act on the email. Unfortunately, we cannot warrant that the email has not been altered or corrupted during transmission. =======================================================================