From mboxrd@z Thu Jan  1 00:00:00 1970
From: Steven Scholz <steven.scholz@imc-berlin.de>
Date: Fri, 22 Oct 2004 09:14:20 +0200
Subject: [U-Boot-Users] Switching of LCD controller before reboot?
Message-ID: <4178B34C.7090106@imc-berlin.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi there,

my i.MX based board does not reboot but hangs when doing "reset" (on u-boot) or 
"reboot" (on linux) when the internal LCD contoller is enabled. Thus I have to 
disable the LCD contoller before doing that.

Something else:

The AT91RM9200DK needs to "shutdown the console to avoid strange chars during 
reset".

So my question is:
Where would be the appropriate place for stuff like that?
Should we clobber cpu/arm920t/cpu.c with all the processor or board specific 
reset related stuff?
Or would it be better to have something like

         cpu_init,               /* basic cpu dependent setup */
         board_init,             /* basic board dependent setup */
...
         cpu_reset,              /* basic cpu dependent reset */
         board_reset,            /* basic board dependent reset */
or
	prepare_reset

based on defines like CONFIG_BOARD_PRE_RESET or something?

Thanks.

-- 
Steven Scholz