From mboxrd@z Thu Jan  1 00:00:00 1970
From: Ilan Finci <list@finci.org>
Date: Wed, 01 Dec 2004 08:44:11 +0200
Subject: [U-Boot-Users] help starting
Message-ID: <41AD683B.9080105@finci.org>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi,
I'm totally new to the world of porting U-Boot (or other boot loaders) 
to new hardware.

I have an older version of U-Boot (0.4.5) that was ported to 2 custom 
made boards we have, based on the MPC5200 CPU, and the IceCube 
evaluation board. Both has the same U-Boot up and running.

We now have a new board, base on the same design, but with some 
modification.

I have BDI2000 up and running, and I can access the board's memory, 
flash, cpu registers etc.

When I try to run the same U-boot, it, as can be expected, fails to run, 
and stop very soon after startup (no message comes out on the serial 
console).

I've tried to connect with GDB to debug, and I manage to do it, then 
step few commands, and I get SIGSTOP. To make sure that this is not a 
problem of the new board, I've tried the same with a working board, and 
the U-Boot fails at the same place (right after the starting point). On 
the other hand, if I don't try to do a step by step debugging, but give 
a "cont" command, the U-boot (on the older board) does work.

So I guess I have a basic problem in understanding how to debug the 
U-Boot with GDB.

Any help (either specific, or pointers to guides), will be great.

Thanks,
Ilan