[U-Boot-Users] help starting

[Ilan Finci <list@finci.org>]

Hi,
Yes I've read it, but when I try this (on the older board, where the 
u-boot is working), the gdb doesn't stop at that function, just continue 
(and over the serial terminal, I see the normal u-boot messages, and 
later auto booting into linux).

Here is the screen dump of what I've done:

U-Boot $ powerpc-linux-gdb u-boot
GNU gdb 5.3
Copyright 2002 Free Software Foundation, Inc.
GDB is free software, covered by the GNU General Public License, and you are
welcome to change it and/or distribute copies of it under certain 
conditions.
Type "show copying" to see the conditions.
There is absolutely no warranty for GDB.  Type "show warranty" for details.
This GDB was configured as "--host=i686-pc-linux-gnu 
--target=powerpc-linux"...
(gdb) target remote jtag2:2001
Remote debugging using jtag2:2001
_start () at /homes/ifinci/secure/work/SeeQNet/U-Boot/cpu/mpc5xxx/start.S:91
91              li      r21, BOOTFLAG_COLD      /* Normal Power-On 
        */
(gdb) b cpu_init_f
Breakpoint 1 at 0xfff03a34: file cpu_init.c, line 53.
(gdb) c
Continuing.


and I don't get the GDB prompt back unless I press CTRL+C.

Any idea?

Thanks,
Ilan

on 12/01/04 09:22 Wolfgang Denk said the following:
> In message <41AD683B.9080105@finci.org> you wrote:
> 
>>So I guess I have a basic problem in understanding how to debug the 
>>U-Boot with GDB.
> 
> 
> Did you read the "Debugging" section in the manual?
> 
> See http://www.denx.de/twiki/bin/view/DULG/DebuggingUBoot
> 
> Best regards,
> 
> Wolfgang Denk
>