From mboxrd@z Thu Jan  1 00:00:00 1970
From: Peter Asemann <peter.asemann@web.de>
Date: Fri, 28 Jan 2005 16:25:29 +0100
Subject: [U-Boot-Users] comment in mpc8xx - cpu_init.c - line 76
Message-ID: <41FA5969.4050107@web.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Line 76 in the most up-to-date version of 
.../u-boot/cpu/mpc8xx/cpu_init.c tells me NOT to change EBDF.
Do I need to stick to this... advice?

The Hard Reset Configuration word of my MPC875-powered hardware is 
hard-wired to set the SCCR[EBDF] to 01 (half bus speed) at hard reset in 
the moment.
I had hoped that I could change SCCR[EBDF] to 00 (full bus speed) via 
software if needed.

So - is the comment in the code some kind of serious warning, for the 
CPU will burn or crash if I try to change EBDF via software, or may I 
ignore it? I'd need the hardware guys to put in some additional jumper 
in case I can't change SCCR[EBDF] by software for some reason.

Thanks for your time,

Peter Asemann