[U-Boot-Users] Problem starting u-boot on Xilinx V2P

[Thorsten Lueck <T.Lueck@IfEN.com>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Wolfgang Denk wrote:
> You cannot just use a configuration for one board and  expect  it  to
> work on a different board.

My board is not as different to ml300 as one may think - indeed, it uses
the same Virtex2Pro FPGA with nearly the same configuration (wrt. UART,
I2C, EMAC). Therefore using ml300 as a starting point for my design
really makes sense. Of course I used the BSP compiled for my board using
Xilinx EDK 7.1

> You missed to port U-Boot to your hardware. Go back to square 0. Read
> the README (porting guide section) and do what needs to be done.
Well - I _did_ port it (in the sense of using the appropriate BSP) -
however, I modified ML300 source instead of creating a new
board-directory ...

> 
>>in the ./lib_i386/board.c, however, there is no appropriate warning in
> 
> What has the x86 code to do with that? [Nothing!]
Well - nothing - your are right - instead of the comment, that the
PowerPC code may hang immediatley _after_ "DRAM:" printout. This led me
to the assumption, that my problem may be well known ...


Best regards,

Thorsten

- --
IfEN - Gesellschaft f?r Satellitennavigation mbH

  Dipl. Ing. Thorsten L?ck
  Tel.:  +49 8121 2238-25
  Fax :  +49 8121 2238-11
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (GNU/Linux)

iD8DBQFCy34yQDwjNlk95KYRAm4vAJ0RGmdP6J+fu6hQdno9/FH0wBKwewCg0rIW
roq+pqfElk34fcgcG++bxLw=
=uFWp
-----END PGP SIGNATURE-----