From mboxrd@z Thu Jan 1 00:00:00 1970 From: Thorsten Lueck Date: Wed, 06 Jul 2005 08:46:13 +0200 Subject: [U-Boot-Users] Problem starting u-boot on Xilinx V2P In-Reply-To: <20050705160823.F1094353A4A@atlas.denx.de> References: <20050705160823.F1094353A4A@atlas.denx.de> Message-ID: <42CB7E35.8090805@IfEN.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Wolfgang Denk wrote: > You cannot just use a configuration for one board and expect it to > work on a different board. My board is not as different to ml300 as one may think - indeed, it uses the same Virtex2Pro FPGA with nearly the same configuration (wrt. UART, I2C, EMAC). Therefore using ml300 as a starting point for my design really makes sense. Of course I used the BSP compiled for my board using Xilinx EDK 7.1 > You missed to port U-Boot to your hardware. Go back to square 0. Read > the README (porting guide section) and do what needs to be done. Well - I _did_ port it (in the sense of using the appropriate BSP) - however, I modified ML300 source instead of creating a new board-directory ... > >>in the ./lib_i386/board.c, however, there is no appropriate warning in > > What has the x86 code to do with that? [Nothing!] Well - nothing - your are right - instead of the comment, that the PowerPC code may hang immediatley _after_ "DRAM:" printout. This led me to the assumption, that my problem may be well known ... Best regards, Thorsten - -- IfEN - Gesellschaft f?r Satellitennavigation mbH Dipl. Ing. Thorsten L?ck Tel.: +49 8121 2238-25 Fax : +49 8121 2238-11 -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.0 (GNU/Linux) iD8DBQFCy34yQDwjNlk95KYRAm4vAJ0RGmdP6J+fu6hQdno9/FH0wBKwewCg0rIW roq+pqfElk34fcgcG++bxLw= =uFWp -----END PGP SIGNATURE-----