[U-Boot-Users] [PATCH] 83xx: Put the version (and magic) after the HRCW.

[Jerry Van Baren <gerald.vanbaren@comcast.net>]

Jerry Van Baren wrote:
> Sam Song wrote:
>> Jerry Van Baren <gerald.vanbaren@comcast.net> wrote:
>>> Put the version (and magic) after the HRCW.  This
>>> puts it in a fixed location in flash, not at the
>> start 
>>> of flash but as close as we can get.
>> Nice effort. Space saving and better version check.
>>
>> I guess the same change could apply for MPC8260/47/8.
>>
>> Thanks,
>>
>> Sam
> 
> Yes.  Most boards have the version in the first bytes of flash, but this
> was not possible on the 82xx because of the HRCW, so it was put in
> .data.  This set up was copied for the 83xx (which also has a HRCW).  My
> change moves it back to .text just after the HRCW.  I put also the
> u-boot magic number back in in honor of Wolfgang. ;-)
> 
> If you change the file names in the patch, it probably would apply.  :-)
>  I intend to do this (perhaps literally), but ran out of ambition tonight.
> 
> Best regards,
> gvb

Arrgh, I forgot about the 8260 master + 7 slaves mode, which fills the 
first 256 bytes with HRCWs.  As a result, we cannot put the magic number 
and version at offset 0x40 like I did with the 8360 (well, we could do 
it, but only if the system doesn't have slaves).  We could, however, put 
the magic number and version in a different vector area that has room 
(e.g. offset 0x240).

What we have works and has worked for several years.  I don't have 
enough ambition and interest at this point to change this for the mpc8260.

Best regards,
gvb