From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ingo Swieter Date: Thu, 14 Jun 2007 13:21:58 +0200 Subject: [U-Boot-Users] bootm shows Kernel info but reset Message-ID: <467124D6.2080105@brunel.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello, i have a problem starting Linux from U-Boot. I compile my Linux-Kernel with the make uImage command and copy it to my tftpboot directory. With U-Boot i can load the image through tftp and the bootm command shows the correct information. But after a while, around half second, it restarts U-Boot again. Do you have any hint for that problem? Best Regards, Ingo --- # t 100000 uImage Using FEC ETHERNET device TFTP from server 172.16.102.78; our IP address is 172.16.102.79 Filename 'uImage'. Load address: 0x100000 Loading: ################################################################# ################################################################# ### done Bytes transferred = 679637 (a5ed5 hex) # bootm 100000 ## Booting image at 00100000 ... Image Name: Linux-2.4.25 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 679573 Bytes = 663.6 kB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK U-Boot 1.2.0 (Jun 14 2007 - 11:03:06) BCS_EPDEV_P01-00 CPU: MPC885ZPnn at 100 MHz [40.0...133.0 MHz] 8 kB I-Cache 8 kB D-Cache FEC present Board: EP88xC 1.1 CPLD revision 2 Watchdog enabled DRAM: 64 MB FLASH: 32 MB In: serial Out: serial Err: serial Net: FEC ETHERNET, FEC2 ETHERNET # -- Ingo Swieter Tel: 05121/1760-821 Mail: ingo.swieter at brunel.de Brunel GmbH Bereich Communications Daimlerring 9 31135 Hildesheim Fax: 05121/1760-999 Internet: http://www.brunel.de Hauptsitz: Airport City, Hermann-K?hl-Str. 1 a, 28199 Bremen Amtsgericht Bremen HRB 16935 General Manager: Carsten Siebeneich