[U-Boot-Users] [PATCH] Added support for multiple serial for MPC8XX (resubmit)

[Wolfgang Grandegger <wg@grandegger.com>]

Detlev Zundel wrote:
> Hi Stefano,
> 
>> The following patch provides support for multiple interface on MPC8xx based 
>> boards as already provided for other cpus (ppc4xx,MPC5200).
>>
>> More information in doc/README.serial_multi
>>
>> In the patch there is also a minor problem solved for the IP860 board 
>> (CONFIG_IP86x missing), that does not allow u-boot 1.2 to run.
>>
>> Signed-off-by:	stefano babic <sbabic@denx.de>
> 
> I am not able to apply this patch, it seems it got mangled by your
> mailer.  Can you please repost as an inline attachment?
> 
> Apart from that, does anyone expect problems if I apply that to the
> repository?

It does not compile for MPC823. Stefano, could you please build it for 
TQM823L as well. To fix it, I changed in cpu/mpc8xx/serial.c:

   #if (!defined(CONFIG_8xx_CONS_SMC1)) && (defined(CONFIG_MPC823) || 
defined(CONFIG_MPC850))
	volatile iop8xx_t *ip = (iop8xx_t *)&(im->im_ioport);
   #endif

into

   #if defined(CONFIG_8xx_CONS_SMC2) && (defined(CONFIG_MPC823) || 
defined(CONFIG_MPC850))
	volatile iop8xx_t *ip = (iop8xx_t *)&(im->im_ioport);
   #endif

Furthermore, to get reduce the #ifdef mess, I would use another method 
to handle compile and run time selection of the serial port. Instead of:

   #ifdef CONFIG_SERIAL_MULTI
	if (smc_index == SMC1_INDEX) {
   #endif
   #if defined(CONFIG_8xx_CONS_SMC1)
		/* Use Port B for SMC1 instead of other functions.
		*/
		cp->cp_pbpar |=  0x000000c0;
		cp->cp_pbdir &= ~0x000000c0;
		cp->cp_pbodr &= ~0x000000c0;
   #endif
   #ifdef CONFIG_SERIAL_MULTI
	}
   #endif

you could simple write:

   if (smc_index == SMC1_INDEX) {
	/* Use Port B for SMC1 instead of other functions.
	*/
	cp->cp_pbpar |=  0x000000c0;
	cp->cp_pbdir &= ~0x000000c0;
	cp->cp_pbodr &= ~0x000000c0;
   }

For the static case, just define smc_index somewhere in a header file:

#ifndef CONFIG_SERIAL_MULTI
#if defined(CONFIG_8xx_CONS_SMC1)
#define smc_index SMC1_INDEX
#elif defined(CONFIG_8xx_CONS_SMC2)
#define smc_index SMC2_INDEX
#endif

The optimizer will then eliminate the unused code. This makes the code 
much more readable, apart from checking the syntax.

Any comments?

Wolfgang.