From mboxrd@z Thu Jan  1 00:00:00 1970
From: stefano babic <sbabic@denx.de>
Date: Thu, 30 Aug 2007 19:17:05 +0200
Subject: [U-Boot-Users] change U-boot file stream to COM2
In-Reply-To: <m27inddntn.fsf@ohwell.denx.de>
References: <20070813094233.4949324041@gemini.denx.de>	<op.twz1epu5i2vpqq@localhost>
	<m27inddntn.fsf@ohwell.denx.de>
Message-ID: <46D6FB91.2000305@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Detlev Zundel wrote:
> Fortunately we are just working on something like this, Stefano (on
> CC), should be able to tell you when this will be finished.

Test is finished. I will send the patch. Multiple serials are supported 
in the same way as they are on the PPC boards.

Javier, at the moment u-boot supports only one serial interface and 
consequently you cannot enable the other ones. You can use any of 
FFUART,BTUART or STUART, but u-boot cannot have more than one serial at 
the same time. The serial driver for PXA27xx does not support it.

After applying the patch I will send, you have to set 
CONFIG_SERIAL_MULTI in your config file and all serials you want to use:

#define CONFIG_SERIAL_MULTI
#define CONFIG_FFUART          1       /* we use FFUART on Conxs */
#define CONFIG_BTUART          1       /* we use BTUART on Conxs */
#define CONFIG_STUART          1       /* we use STUART on Conxs */

You have to provide also a function in your board.c file to return the 
default serial device, such as:

struct serial_device *default_serial_console (void)
{
         return &serial_ffuart_device;
}

or whatever you prefer.

On my target (PXA270) I get:
U-Boot 1.2.0-gc7d2ba2d-dirty (Aug 23 2007 - 15:47:09)

DRAM:  64 MB
Flash: 32 MB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0
$ coninfo
List of available devices:
serial   80000003 SIO stdin stdout stderr
nulldev  80000003 SIO
serial_stuart 00000003 .IO
serial_btuart 00000003 .IO
serial_ffuart 00000003 .IO

Then you will be able to switch among the serials setting the stdout, 
stdin and stderr variables. For example, to switch to the BTUART:

	setenv stdout serial_btuart
	setenv stdin serial_btuart


Regards,
stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================