From mboxrd@z Thu Jan 1 00:00:00 1970 From: Andreas Schweigstill Date: Thu, 13 Sep 2007 15:12:10 +0200 Subject: [U-Boot-Users] R: Booting with attached BDI but not alone (onlyICTRL remained in BDI cfg) In-Reply-To: References: Message-ID: <46E9372A.1050605@schweigstill.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello! DI BACCO ANTONIO - technolabs schrieb: > I verified that SRESET on the BDM connector is pulled up (on the > schematic). I tried to pull up it with a wire but it doesn't work. Have you used a voltage meter or oscilloscope to check the voltage level? Have you measured the resistance between SRESET and GND and between SRESET and supply? Have you checked if your processor pin is connected? Probably either the pull-up resistor isn't mounted or your PCB is defective. With best regards Andreas Schweigstill -- Dipl.-Phys. Andreas Schweigstill Schweigstill IT | Embedded Systems Schauenburgerstra?e 116, D-24118 Kiel, Germany Phone: (+49) 431 5606-435, Fax: (+49) 431 5606-436 Mobile: (+49) 171 6921973, Web: http://www.schweigstill.de/