[U-Boot-Users] minimum bdi config to read flash on 85xx

[Ben Warren <bwarren@qstreams.com>]

robert lazarski wrote:
<snip>
> OK guys, its working!!!! YEAH!!!! Last problem turned out to be an
> open resistor / bad solder joint on the address bus! We can now erase
> the flash chip entirely. I also did the prog command to upload
> uboot.bin and can see the uboot version at the base address - so this
> stage is now completed!!!! Thanks so much for all the help guys, I
> doubt we would have gotten so far without this community and we are
> most grateful! I feel so much smarter now ;-) .
>
> Last question before I get into my code finally - and I'll start a new
> thread when I start debugging: The bdi docs in the uboot manual seem
> to stop at the 'go' command. When I type 'info' I get a running state.
> Can I now just power on and attach a terminal via the serial port to
> get the uboot shell? To get to that point is the next dragon to slay?
>
> Thanks!!!
> Robert
>   
Congratulations! Now you're equipped to help the next guy/girl.

Hook up your serial cable and with any luck you'll get something!

regards,
Ben