From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ben Warren Date: Fri, 14 Sep 2007 16:14:31 -0400 Subject: [U-Boot-Users] minimum bdi config to read flash on 85xx In-Reply-To: References: <46E82959.2090107@ovro.caltech.edu> <46E82C47.8050708@smiths-aerospace.com> <46E8300E.8040109@ovro.caltech.edu> <46E83245.5060604@smiths-aerospace.com> <46E8338C.1090704@ovro.caltech.edu> <46E84102.3010800@ovro.caltech.edu> <46EADD19.901@ovro.caltech.edu> Message-ID: <46EAEBA7.1000100@qstreams.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de robert lazarski wrote: > OK guys, its working!!!! YEAH!!!! Last problem turned out to be an > open resistor / bad solder joint on the address bus! We can now erase > the flash chip entirely. I also did the prog command to upload > uboot.bin and can see the uboot version at the base address - so this > stage is now completed!!!! Thanks so much for all the help guys, I > doubt we would have gotten so far without this community and we are > most grateful! I feel so much smarter now ;-) . > > Last question before I get into my code finally - and I'll start a new > thread when I start debugging: The bdi docs in the uboot manual seem > to stop at the 'go' command. When I type 'info' I get a running state. > Can I now just power on and attach a terminal via the serial port to > get the uboot shell? To get to that point is the next dragon to slay? > > Thanks!!! > Robert > Congratulations! Now you're equipped to help the next guy/girl. Hook up your serial cable and with any luck you'll get something! regards, Ben