[U-Boot-Users] Debugging 85xx eTSEC's

[Clemens Koller <clemens.koller@anagramm.de>]

robert lazarski schrieb:
 > Thanks Clemens for the kind review you gave us off list. In the case
> its might help someone else someday, we found the problem as our
> pinouts were wrong to the NET's
> 
> -PIN of the PHY-           -NAME we gave to the NET-
>  LED_LINK_10                      LED_LINK_100
>  LED_LINK_100                    LED_LINK_1000
>  LED_LINK_1000                 LED_DUPLEX
>  LED_LINK_DUPLEX          LED_LINK_10
> 
> We can now ping, use tftp etc.
> Robert

Fine to hear it is working now! And thanks for the flowers. ;-)
I also had to check the PHY configuration on my board many times
to make sure everything is right. It's easy to make mistakes here. @:-]

There is propably a way to show and re-configure this at run-time
with u-boot via the mdio interface, isn't it?

Regards,

-- 
Clemens Koller
_______________________________
R&D Imaging Devices
Anagramm GmbH
Rupert-Mayer-Str. 45/1
81379 Muenchen
Germany

http://www.anagramm-technology.com
Phone: +49-89-741518-50
Fax: +49-89-741518-19