From mboxrd@z Thu Jan 1 00:00:00 1970 From: llandre Date: Tue, 22 Jan 2008 15:09:19 +0100 Subject: [U-Boot-Users] Support for SRAM in u-boot In-Reply-To: <115A3AE4BC001B47BDE607FDE8DBEB3004A14DFC@OXCH30IV.int.olivetti.corp> References: <115A3AE4BC001B47BDE607FDE8DBEB3004A14DFC@OXCH30IV.int.olivetti.corp> Message-ID: <4795F90F.3020909@dave-tech.it> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Marco, U-Boot provides generic commands to read/write memory locations (md/mw respectively) no matter where they physically are. Once your memory controller is set up properly (chip select timing etc.) you can easily access the SRAM from U-Boot shell. HTH, llandre DAVE Electronics System House - R&D Department web: http://www.dave.eu email: r&d2 at dave-tech.it > > > Hi all, > we are developing a product based on AT91SAM9261 and equipped with > u-boot v 1.1.5 and linux kernel v 2.6.22.1. > Since our HW architecture foresee a SRAM (1Mx16 and 55 ns of speed time) > like the Cypress62167DV3011-55 we need to know if u-boot has the support > for it. > Thanks a lot in anticipation for any kind of help/info. > Best regards, > Marco Cacre > Olivetti S.p.a > > > ------------------------------------------------------------------------ > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > > > ------------------------------------------------------------------------ > > _______________________________________________ > U-Boot-Users mailing list > U-Boot-Users at lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/u-boot-users