[U-Boot-Users] [PATCH 6/6] [new uImage] Move FDT error printing to common fdt_error() routine

[Jerry Van Baren <gerald.vanbaren@ge.com>]

Marian Balakowicz wrote:
> FDT error handling in PPC do_bootm_linux() shares the same message format.
> This patch moves error message printing to a helper fdt_error() routine.
> 
> Signed-off-by: Marian Balakowicz <m8@semihalf.com>
> ---
> 
>  lib_ppc/bootm.c |   50 ++++++++++++++++++++++++--------------------------
>  1 files changed, 24 insertions(+), 26 deletions(-)

[snip]

> @@ -310,8 +306,7 @@ do_bootm_linux(cmd_tbl_t *cmdtp, int flag,
>  
>  			of_flat_tree = (char *)image_get_load (fdt_hdr);
>  		} else {
> -			puts ("Did not find a flat Flat Device Tree.\n"
> -				"Must RESET the board to recover.\n");
> +			fdt_error ("Did not find a flat Flat Device Tree");

Ouch, I messed that one up pretty badly in the original.  Should be
   "Did not find a Flattened Device Tree"
   s/flat Flat/Flattened/

[snip]

>  #endif
>  #ifdef CONFIG_OF_HAS_BD_T
>  		if (fdt_bd_t(of_flat_tree) < 0) {
> -			puts ("ERROR: /bd_t node create failed - "
> -				"must RESET the board to recover.\n");
> +			fdte_error ("/bd_t node create failed");

Typo s/fdte_error/fdt_error/

[snip]

FWIIW, with the above changes...

Acked-by: Gerald Van Baren <vanbaren@cideas.com>

Good improvement, thanks.
gvb