[U-Boot-Users] [PATCH] Extend ATI Radeon driver to support more video modes

[Anatolij Gustschin <agust@denx.de>]

Hello,

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 10:24 Fri 15 Feb     , Rodolfo Giometti wrote:
>> On Thu, Feb 14, 2008 at 01:39:14AM +0100, Wolfgang Denk wrote:
>>> In message <47B38277.6010001@denx.de> you wrote:
>>>>>> +#if 1 /* @ 60 Hz */
>>>>>> +		mode->crtc_h_total_disp = 0x009f00d2;
>>>>>> +		mode->crtc_h_sync_strt_wid = 0x000e0528;
>>>>>> +		mode->crtc_v_total_disp = 0x03ff0429;
>>>>>> +		mode->crtc_v_sync_strt_wid = 0x00030400;
>>>>>> +		mode->crtc_pitch = 0x00a000a0;
>>>>>> +		mode->ppll_div_3 = 0x00010060;
>>>>>> +#else /* @ 75 Hz */
>>>>>> +		mode->crtc_h_total_disp = 0x009f00d2;
>>>>>> +		mode->crtc_h_sync_strt_wid = 0x00120508;
>>>>>> +		mode->crtc_v_total_disp = 0x03ff0429;
>>>>>> +		mode->crtc_v_sync_strt_wid = 0x00030400;
>>>>>> +		mode->crtc_pitch = 0x00a000a0;
>>>>>> +		mode->ppll_div_3 = 0x00010078;
>>>>>> +#endif
>>>>> Mmm... better adding a configuration define here or just remove the
>>>>> unused code.
>>>> Ok, I'm going to drop the unused code then.
>>> No, please keep it as reference in case anybody needs this later.
>> Uh? =:-o Why did you change your mind? ;)
>>
>> |  Delivery-date: Sun, 01 Apr 2007 15:18:41 +0200
>> |  From: Wolfgang Denk <wd@denx.de>
>> |  To: Rodolfo Giometti <giometti@enneenne.com>
>> |  cc: Markus Klotzb?cher <mk@denx.de>
>> |  Subject: Re: [PATCH] ISP116x HCD (Host Controller Driver)
>> |
>> |  [snip]
>> |
>> |  Please remove code in "#if 0 ... #endif" blocks.
>> |
>> |  [snip]
>> |
>> |  Best regards,
>> |
>> |  Wolfgang Denk
>>
>> However I suggested also to add a configuration define, something
>> like:
>>
>> #if defined(CFG_ATI_RADEON_60HZ)
>> ...
>> #elif defined(CFG_ATI_RADEON_75HZ)
>> ...
>> #else
>> #error "..."
>> #endif
>>
> Please use CONFIG and not CFG too allow this parameter in Kconfig

new and already applied patch uses CONFIG_RADEON_VREFRESH_75HZ and
another case (@ 60HZ) is just default case.

Best Regards,

Anatolij

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de