[U-Boot-Users] [PATCH] fix non-working mvBL-M7

André Schwarz
2008-06-26T06:29:26Z

Kim,

thanks - ok.

Switching to U_BOOT_VERSION should be no problem.

regards,
Andr?

Kim Phillips schrieb:
> On Mon, 23 Jun 2008 13:25:34 +0200
> Andre Schwarz <andre.schwarz@matrix-vision.de> wrote:
>
> Hello Andre,
>
>> diff --git a/include/configs/MVBLM7.h b/include/configs/MVBLM7.h
>> index 349ca14..8c0e8b6 100644
>> --- a/include/configs/MVBLM7.h
>> +++ b/include/configs/MVBLM7.h
>> @@ -27,7 +27,7 @@
>> #ifndef __CONFIG_H
>> #define __CONFIG_H
>>
>> -#define MV_VERSION "v1.0.1"
>> +#define MV_VERSION "v1.0.2"
>
> instead of incrementing this for each patch, can we just use
> U_BOOT_VERSION instead?
>
>> #define CONFIG_HAS_ETH0
>> +#define CONFIG_ETHADDR b6:b4:45:eb:fb:c0
>> #define CONFIG_TSEC1_NAME "TSEC0"
>> #define CONFIG_FEC1_PHY_NORXERR
>> #define CFG_TSEC1_OFFSET 0x24000
>> @@ -224,6 +225,7 @@
>> #define TSEC1_FLAGS (TSEC_GIGABIT|TSEC_REDUCED)
>>
>> #define CONFIG_HAS_ETH1
>> +#define CONFIG_ETH1ADDR b6:b4:45:eb:fb:c2
>> #define CONFIG_TSEC2_NAME "TSEC1"
>
> I had removed this from your original board port because this goes
> against recommended practice; see:
>
> http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/41178
>
>> +#define CONFIG_HIGH_BATS 1
>
> this line applied.
>
> Kim