[U-Boot-Users] [PATCH v2] net: smc911x: Add support RSK7203 board to smc911x

[Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>]

The RSK board has the SMSC9118 wired up 'incorrectly'.
Byte-swapping is necessary, and so poor performance is inevitable.
This problem cannot evade by the swap function of CHIP, this can
evade by software Byte-swapping.
And this has problem by FIFO access only. pkt_data_pull/pkt_data_push
functions necessary to solve this problem.

Signed-off-by: Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>
---
 drivers/net/smc911x.c |   34 +++++++++++++++++++++++++++++++---
 1 files changed, 31 insertions(+), 3 deletions(-)

diff --git a/drivers/net/smc911x.c b/drivers/net/smc911x.c
index 1484b0b..cc8aaf0 100644
--- a/drivers/net/smc911x.c
+++ b/drivers/net/smc911x.c
@@ -1,5 +1,5 @@
 /*
- * SMSC LAN9[12]1[567] Network driver
+ * SMSC LAN9[12]1[5678] Network driver
  *
  * (c) 2007 Pengutronix, Sascha Hauer <s.hauer@pengutronix.de>
  *
@@ -26,6 +26,7 @@
 #include <command.h>
 #include <net.h>
 #include <miiphy.h>
+#include <asm/byteorder.h>

 #if defined (CONFIG_DRIVER_SMC911X_32_BIT) && \
 	defined (CONFIG_DRIVER_SMC911X_16_BIT)
@@ -53,6 +54,33 @@ static inline void reg_write(u32 addr, u32 val)
 	*(volatile u16*)addr = (u16)val;
 	*(volatile u16*)(addr + 2) = (u16)(val >> 16);
 }
+
+#if defined(CONFIG_RSK7203)
+/*
+ * The RSK board has the SMSC9118 wired up 'incorrectly'.
+ * Byte-swapping is necessary, and so poor performance is inevitable.
+ * This problem cannot evade by the swap function of CHIP, this can
+ * evade by software Byte-swapping.
+ * And this has problem by FIFO access only. pkt_data_pull/pkt_data_push
+ * functions necessary to solve this problem.
+ */
+static inline u32 pkt_data_pull(u32 addr)
+{
+	volatile u16 *addr_16 = (u16 *)addr;
+	return (((swab16(*addr_16) << 16) & 0xFFFF0000)|swab16(*(addr_16 + 1)));
+}
+
+static inline void pkt_data_push(u32 addr, u32 val)
+{
+	*(volatile u16 *)(addr + 2) = swab16((u16)val);
+	*(volatile u16 *)(addr) = swab16((u16)(val >> 16));
+}
+
+#else
+# define pkt_data_pull(x) reg_read(x)
+# define pkt_data_push(x, l) reg_write(x, l)
+#endif /* CONFIG_RSK7203 */
+
 #else
 #error "SMC911X: undefined bus width"
 #endif /* CONFIG_DRIVER_SMC911X_16_BIT */
@@ -641,7 +669,7 @@ int eth_send(volatile void *packet, int length)
 	tmplen = (length + 3) / 4;

 	while (tmplen--)
-		reg_write(TX_DATA_FIFO, *data++);
+		pkt_data_push(TX_DATA_FIFO, *data++);

 	/* wait for transmission */
 	while (!((reg_read(TX_FIFO_INF) & TX_FIFO_INF_TSUSED) >> 16));
@@ -684,7 +712,7 @@ int eth_rx(void)

 		tmplen = (pktlen + 2+ 3) / 4;
 		while (tmplen--)
-			*data++ = reg_read(RX_DATA_FIFO);
+			*data++ = pkt_data_pull(RX_DATA_FIFO);

 		if (status & RX_STS_ES)
 			printf(DRIVERNAME
-- 
1.5.5.1