[U-Boot] mpc83xx U-boot questions

[Yuke Tian <ytian@bnl.gov>]

Thanks.

To be specific, I followed the steps to build RTEMS:
1) Download a set of toolsets (gcc-4.2.3, binutils-2.18, newlib-1.16 and
RTEMS specific patches) and build them or use the pre-built rpm toolset
for RHLE5.
2) Download the RTEMS (4.9.0 for the latest version) and use the toolset
to build RTEMS.
3) Compile a RTEMS application,  tailed for specific BSP.  That is where
I get .exe (it is ELF 32-bit MSB executable, PowerPC or cisco 4500,
version 1 (SYSV), statically linked, not stripped).  I just want to use
the vendor provided U-Boot to download the .exe and get it run. I didn't
expect to rebuilt U-Boot, but that might be educational :-)          

Yuke



Jerry Van Baren wrote:
> Yuke Tian wrote:
>> Hi,
>>
>> Sorry to ask the stupid question. I did study the RTEMS for a while and
>> am sure the tool set are correct (from ftp://www.rtems.com), otherwise
>> they will not build RTEMS.  All the tools and development are done in
>> linux (RHLE5).  I just got this board using U-boot and not sure about
>> it. David's manual help a lot. Thanks.
>>
>> Yuke
>
> I didn't call your question stupid, just clueless.  ;-)
>
> It sounds like you are coming up to speed rapidly, including providing
> useful background information and asking smart questions.  You might
> add the following to your reading list:
>   <http://www.catb.org/esr/faqs/smart-questions.html>
>
> Best regards,
> gvb
>