[U-Boot] GPIO configuration on 460EX

[Felix Radensky <felix@embedded-sol.com>]

Hi, Stefan

Stefan Roese wrote:
> Hi Felix,
>
> On Thursday 16 October 2008, Felix Radensky wrote:
>   
>> I'm looking at GPIO setup code for Canyonlands, and
>> it looks like some initializations mentioned in the 460EX
>> manual are missing. When pin is configured as alternate
>> input, the corresponding bits in TSRL/H registers should
>> be set. U-Boot code sets TSRL/H registers only for output
>> pins.
>>
>> Am I missing something ?
>>     
>
> Looking again at the users manual I can't find that the TSR register should be 
> set for input functionality. Take a look at figure 35-1. Here you will see 
> that TSR is only involved for output functionality.
>
>   
I was looking at section 35.5.3 and Table 35-9 in user manual (Version 1.14)
TSR is involved in both input and output functionality. This indeed 
contradicts
the description you were referring to. Maybe AMCC guys reading this list can
clarify ?
> I assume that you are asking because of your Linux IRQ problem with the 
> external interrupt, correct? I'll take a look at the Linux thread and try to 
> give another answer there.
>   
Thanks a lot. Your suggestion in this thread indeed helped. I was using
wrong IRQ number in device tree.
> And feel free to test with TSR configured for input as well. If this gets your 
> interrupt working then this we need to change this GPIO config code of 
> course.
>
>   
I've tried that, but it didn't help.

Thanks a lot for you help.

Felix.