From mboxrd@z Thu Jan 1 00:00:00 1970 From: Andre Schwarz Date: Tue, 09 Dec 2008 11:35:01 +0100 Subject: [U-Boot] FSL DDR @ 83xx In-Reply-To: <20081208140139.5ffe5a39.kim.phillips@freescale.com> References: <493D530A.8040409@matrix-vision.de> <20081208140139.5ffe5a39.kim.phillips@freescale.com> Message-ID: <493E49D5.9030004@matrix-vision.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Kim Phillips schrieb: > On Mon, 08 Dec 2008 18:02:02 +0100 > Andre Schwarz wrote: > > >> I'd like to change my DDR setup code since it looks like my computed >> values are not perfectly stable on our 8343 based board. >> >> This implies using a fake SPD and the related code to set up the controller. >> >> Is the "new" common FSL DDR setup code (cpu/mpc8xxx/ddr/*) stable for >> 83xx or shall I stick to cpu/mpc83xx/spd_sdram.c for a while ? >> > > I haven't taken a look at the "new" common ddr code, and there are no > current 83xx users that I know of, but if you're willing to port it > over to 83xx, it should work better for you than the current 83xx spd > code, and give us a basis to work on to move the rest of the 83xx boards > over. > > Kim > ok - thanks. That's why I'm asking ... no 83xx yet. I'll try the default spd driver with fake EEPROM then. regards, Andr? MATRIX VISION GmbH, Talstra?e 16, DE-71570 Oppenweiler - Registergericht: Amtsgericht Stuttgart, HRB 271090 Gesch?ftsf?hrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner