[U-Boot] [PATCH] ARM: add IDE init to lib_arm/board.c Part 1/1

From: michael <trimarchi@gandalf.sssup.it>
To: u-boot@lists.denx.de
Subject: [U-Boot] [PATCH] ARM: add IDE init to lib_arm/board.c Part 1/1
Date: Wed, 17 Dec 2008 14:10:57 +0100	[thread overview]
Message-ID: <4948FA61.8000604@gandalf.sssup.it> (raw)
In-Reply-To: <4948F480.6040000@gandalf.sssup.it>

michael wrote:
> Stefan Althoefer wrote:
>   
>> Jean-Christophe PLAGNIOL-VILLARD schrieb:
>>
>>   
>>     
>>>> diff -uprN u-boot-orig//lib_arm/board.c u-boot/lib_arm/board.c
>>>> --- u-boot-orig//lib_arm/board.c	2008-12-02 17:25:32.000000000 +0100
>>>> +++ u-boot/lib_arm/board.c	2008-12-02 23:29:36.000000000 +0100
>>>> @@ -441,6 +441,11 @@ extern void davinci_eth_set_mac_addr (co
>>>>  	}
>>>>  #endif
>>>>  
>>>> +#if defined(CONFIG_CMD_IDE)
>>>> +        puts("IDE:   ");
>>>> +        ide_init();
>>>> +#endif /* CONFIG_CMD_IDE */
>>>>       
>>>>         
>>> are you sure it will work?
>>>
>>> Best Regards,
>>> J.
>>>     
>>>       
>> On my board (Janz emPC-A400 with IXP425) it does. With some more
>> patches to add IDE to this board.
>>
>> What is your doubt?
>>
>> If you see problems, drop this. I can also add IDE to board_late_init().
>>   
>>     
> I don't sure if the outsw/insw are implemented in arm.
>
> Regards Michael
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>
>   
Well, I'm not sure :( if the outsw/insw are implemented in arm.

Regards Michael