[U-Boot] [PATCH v3] Add support for the digsy MTC board.

[Ben Warren <biggerbadderben@gmail.com>]

Hi Grzegorz,

Grzegorz Bernacki wrote:
> This is the InterControl custom device based on the MPC5200B chip.
>
> Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>
> ---
> Version 3:
>  - updated (c)
> Version 2:
>  - use I/O accessor functions instead of volatile pointer
>  - set ethernet address only if not set in environment
>  - add some comments and some style cleanup
>
>   
<snip>
> diff --git a/drivers/net/mpc5xxx_fec.c b/drivers/net/mpc5xxx_fec.c
> index f8618b1..a1c72d6 100644
> --- a/drivers/net/mpc5xxx_fec.c
> +++ b/drivers/net/mpc5xxx_fec.c
> @@ -893,6 +893,7 @@ int mpc5xxx_fec_initialize(bd_t * bis)
>  	fec->rbdBase = (FEC_RBD *)(FEC_BD_BASE + FEC_TBD_NUM * sizeof(FEC_TBD));
>  #if defined(CONFIG_CANMB)		|| \
>  	defined(CONFIG_CM5200)		|| \
> +	defined(CONFIG_DIGSY_MTC)	|| \
>  	defined(CONFIG_HMI1001)		|| \
>  	defined(CONFIG_ICECUBE)		|| \
>  	defined(CONFIG_INKA4X0)		|| \
>   
No more adding to this mess, please.  This absolutely belongs in board 
code.  I know you're not responsible for it, so if you don't have time 
to clean it up I can do so and supply an untested patch.

<snip>

regards,
Ben