[U-Boot] [PATCH 08/12 v2] 83xx, kmeter: QE_ENET10 errata for Silicon Revision 2.1

[Heiko Schocher <hs@denx.de>]

old code implemented the QE_ENET10 errata only for Silicon
Revision 2.0. New code reads now the Silicon Revision
register and sets dependend on the Silicon Revision the
values as advised in the QE_ENET10 errata.

Signed-off-by: Heiko Schocher <hs@denx.de>
---
changes since v1:
- get_svr no longer needed, so I didn;t add this fn to start.S

 board/keymile/kmeter1/kmeter1.c |   20 ++++++++++++--------
 1 files changed, 12 insertions(+), 8 deletions(-)

diff --git a/board/keymile/kmeter1/kmeter1.c b/board/keymile/kmeter1/kmeter1.c
index 0b0c2a3..45e98c5 100644
--- a/board/keymile/kmeter1/kmeter1.c
+++ b/board/keymile/kmeter1/kmeter1.c
@@ -24,6 +24,7 @@
 #include <miiphy.h>
 #include <asm/io.h>
 #include <asm/mmu.h>
+#include <asm/processor.h>
 #include <pci.h>
 #include <libfdt.h>

@@ -80,19 +81,22 @@ static int board_init_i2c_busses (void)

 int board_early_init_r (void)
 {
-	void *reg = (void *)(CONFIG_SYS_IMMR + 0x14a8);
-	u32 val;
+	unsigned short	svid;

+	svid =  SVR_REV(mfspr (SVR));
 	/*
 	 * Because of errata in the UCCs, we have to write to the reserved
 	 * registers to slow the clocks down.
 	 */
-	val = in_be32 (reg);
-	/* UCC1 */
-	val |= 0x00003000;
-	/* UCC2 */
-	val |= 0x0c000000;
-	out_be32 (reg, val);
+	switch (svid) {
+	case 0x0020:
+		setbits_be32((void *)(CONFIG_SYS_IMMR + 0x14a8), 0x0c003000);
+		break;
+	case 0x0021:
+		clrsetbits_be32((void *)(CONFIG_SYS_IMMR + 0x14ac),
+			0x00000050, 0x000000a0);
+		break;
+	}
 	/* enable the PHY on the PIGGY */
 	setbits (8, (void *)(CONFIG_SYS_PIGGY_BASE + 0x10003), 0x01);

-- 
1.6.0.6

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany