[U-Boot] [PATCH 2/2] at91: Add support for esd MEESC board

[Daniel Gorsulowski <Daniel.Gorsulowski@esd.eu>]

Hi Jean-Christophe,

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 10:24 Fri 27 Mar     , Daniel Gorsulowski wrote:
>> This patch adds support for MEESC board from esd gmbh.
>> The MEESC is based on an Atmel AT91SAM9263 SoC.
>>
>> Signed-off-by: Daniel Gorsulowski <Daniel.Gorsulowski@esd.eu>
>> ---
> please rebase your patch against
> 
> git://git.denx.de/u-boot-at91.git branch clock
> 
> Best Regards,
> J.

sorry, but my board does not boot by this branch.
Followed by the bootstrapper-"RomBOOT"-prompt just some cryptical characters
appear. Seems like the cpu clock is not initialized correctly.
The board uses an 16.0 Mhz crystal.
I configured as followed:

/* ARM asynchronous clock */
#define AT91_CPU_NAME		"AT91SAM9263"
#define AT91_MAIN_CLOCK		16000000	/* 16.0 MHz crystal */
#define CONFIG_SYS_HZ		1000		/* decrementer freq */

#define CONFIG_MEESC			1	/* Board is esd MEESC */
#define CONFIG_ARM926EJS		1	/* This is an ARM926EJS Core */
#define CONFIG_AT91SAM9263		1	/* It's an AT91SAM9263 SoC*/
#define CONFIG_ARCH_CPU_INIT		1
...


If I build from git://git.denx.de/u-boot.git branch master after applying
my patches, the board boots up correctly.

Best Regards,
Daniel