From mboxrd@z Thu Jan  1 00:00:00 1970
From: prathika <prathika@deeopl.com>
Date: Thu, 09 Apr 2009 13:52:53 +0530
Subject: [U-Boot] Interrupt handlers in u-boot
In-Reply-To: <200904090906.18720.sr@denx.de>
References: <49DC8432.8050306@deeopl.com> <200904081442.01543.sr@denx.de>
	<49DD940A.1070703@deeopl.com> <200904090906.18720.sr@denx.de>
Message-ID: <49DDB05D.2090109@deeopl.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

i am using PPC 440 EP. i used mtdcr definitions available in uboot. i 
understand the UIC dcr registers are directly accessable.
I have configured IRQ0 as interrupt by writing to the following registers=>
GPIO1_TCR[8]=0
GPIO1_TSRL[16:17]=00
GPIO1_ISR1L[16:17]=01

And when thought it could a hardware issue on my board as the IRQ0 is 
connected to the CPLD, i tried configuring IRQ1. the state of IRQ1 is low.
when i enable UIC0_ER register for IRQ1, there is no interrupt 
generated.but when i enable UIC0_PR for IRQ1 to be detected in positive 
polarity, an interrupt is generated with a bogus interrupt message. Did 
i understand the UIC0_PR register functionality wrong?

Thank & Regards,
Prathika R


Stefan Roese wrote:
> On Thursday 09 April 2009, prathika wrote:
>> i got the interrupt handler working for SPI Receive in PPC 440 using
>> install_hdlr().
>> Now i am trying to enable the External IRQ0 in my stand alone
>> application. I am trying to detect the positive of the interrupt pulse,
>> so i wrote corresponding bit to the UIC0_PR  and UIC0_EN register and
>> also calling the install_hdlr().
>> but still it detects the zero state at the IRQ0 pin and always executes
>> the interrupt handler.
>> when i read back the DCRs UIC0 enable and polarity registers using my
>> application, the control word is fine.
>> but when i read using uboot commands getdcr in command window, the
>> status of both enable and polarity registers are not enabled for IRQ0.
>> when i try to set the corresponding bit for IRQ0 using setdcr, it gives
>> me message, "Masking bogus interrupt for 0x17"
>> where am i going wrong.Some one please help.
>> Thanks in advance.
> 
> So which PPC440 variant are you using? And how did you configure the UIC 
> registers exactly? And is IRQ0 perhaps multiplexed with another multifunction 
> pin (see GPIO chapter)?
> 
> Best regards,
> Stefan
> 
> =====================================================================
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
> =====================================================================