From mboxrd@z Thu Jan  1 00:00:00 1970
From: Tom <Tom.Rix@windriver.com>
Date: Fri, 15 May 2009 16:16:29 -0500
Subject: [U-Boot] [PATCH 5/6] ZOOM2 Add serial support.
In-Reply-To: <20090508193643.GB28925@game.jcrosoft.org>
References: <1241731686-9844-1-git-send-email-Tom.Rix@windriver.com>
	<1241731686-9844-2-git-send-email-Tom.Rix@windriver.com>
	<1241731686-9844-3-git-send-email-Tom.Rix@windriver.com>
	<1241731686-9844-4-git-send-email-Tom.Rix@windriver.com>
	<1241731686-9844-5-git-send-email-Tom.Rix@windriver.com>
	<20090508193643.GB28925@game.jcrosoft.org>
Message-ID: <4A0DDBAD.5020703@windriver.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 16:28 Thu 07 May     , Tom Rix wrote:
>   
>> Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board.
>> The default serial is from the USB connector on left side of the debug board.
>>
>> +/*
>> + * This the the zoom2, board specific, gpmc configuration for the
>> + * quad uart on the debug board.   The more general gpmc configurations
>> + * are setup at the cpu level in cpu/arm_cortexa8/omap3/mem.c
>> + */
>> +extern void enable_gpmc_config(u32 *gpmc_config, gpmc_csx_t *gpmc_cs_base,
>> +			       u32 base, u32 size);
>> +
>> +static u32 gpmc_serial_TL16CP754C[GPMC_MAX_REG] = {
>> +	0x00011000,
>> +	0x001F1F01,
>> +	0x00080803,
>> +	0x1D091D09,
>> +	0x041D1F1F,
>> +	0x1D0904C4, 0
>> +};
>>  
>>     
> Any chance to have comment at least about these value?
>
> Best Regards,
> J.
>   

I have not gotten a response for a better comment.

Can I have a pass on this ?

Tom