[U-Boot] [PATCH 5/6] ZOOM2 Add serial support.

[Tom <Tom.Rix@windriver.com>]

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 16:16 Fri 15 May     , Tom wrote:
>   
>> Jean-Christophe PLAGNIOL-VILLARD wrote:
>>     
>>> On 16:28 Thu 07 May     , Tom Rix wrote:
>>>   
>>>       
>>>> Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board.
>>>> The default serial is from the USB connector on left side of the debug board.
>>>>
>>>> +/*
>>>> + * This the the zoom2, board specific, gpmc configuration for the
>>>> + * quad uart on the debug board.   The more general gpmc configurations
>>>> + * are setup at the cpu level in cpu/arm_cortexa8/omap3/mem.c
>>>> + */
>>>> +extern void enable_gpmc_config(u32 *gpmc_config, gpmc_csx_t *gpmc_cs_base,
>>>> +			       u32 base, u32 size);
>>>> +
>>>> +static u32 gpmc_serial_TL16CP754C[GPMC_MAX_REG] = {
>>>> +	0x00011000,
>>>> +	0x001F1F01,
>>>> +	0x00080803,
>>>> +	0x1D091D09,
>>>> +	0x041D1F1F,
>>>> +	0x1D0904C4, 0
>>>> +};
>>>>      
>>>>         
>>> Any chance to have comment at least about these value?
>>>
>>>       
>> I have not gotten a response for a better comment.
>>
>> Can I have a pass on this ?
>>     
> ok but add a comment in the code and the commit to explain why you can not
> provide comment about these values
>
>   
Ok
> Best Regards,
> J.
>