[U-Boot] [PATCH-ARM 4/4] Clean-up of s3c24x0 nand driver

[abdoulaye Walsimou Gaye <walsimou@walsimou.com>]

Wolfgang Denk a ?crit :
> Dear Scott Wood,
>
> In message <20090911222349.GA26604@b07421-ec1.am.freescale.net> you wrote:
>   
>> On Mon, Sep 07, 2009 at 12:15:22AM +0100, kevin.morfitt at fearnside-systems.co.uk wrote:
>>     
>>> This patch re-formats the arm920t s3c24x0 nand driver in preparation for changes
>>> to add support for the Embest SBC2440-II Board.
>>>
>>> The changes are as follows:
>>> - re-indent the code using Lindent
>>> - make sure register layouts are defined using a C struct
>>> - replace the upper-case typedef'ed C struct names with lower case
>>> non-typedef'ed ones
>>> - make sure registers are accessed using the proper accessor functions
>>> - run checkpatch.pl and fix any error reports
>>>
>>> It assumes the following patch has been applied first:
>>> - [U-Boot][PATCH-ARM] CONFIG_SYS_HZ fix for ARM902T S3C24X0 Boards, 05/09/2009
>>>  - patches 1/4, 2/4 and 3/4 of this series
>>>       
>> Acked-by: Scott Wood <scottwood@freescale.com>
>>     
>
> What does that ACK mean? Who is supposed to apply this patch - the ARM
> custodian?
>
> Best regards,
>
> Wolfgang Denk
>
>   

Some of these patches are line wrapped, kevin promised to fix his email 
client and resend

cheers,