[U-Boot] [PATCH 4/4 v3] s5pc1xx: add support SMDKC100 board

[Tom <Tom.Rix@windriver.com>]

Kyungmin Park wrote:
> On Wed, Sep 23, 2009 at 9:05 PM, Tom <Tom.Rix@windriver.com> wrote:
>> Minkyu Kang wrote:
>>> Dear Tom
>>>
>>> 2009/9/23 Tom <Tom.Rix@windriver.com>:
>>>> Minkyu Kang wrote:
>>>>> Adds new board SMDKC100 that uses s5pc100 SoC
>>>>>
>>>>> Signed-off-by: Minkyu Kang <mk7.kang@samsung.com>
>>>>> Signed-off-by: HeungJun, Kim <riverful.kim@samsung.com>
>>>>> ---
>> <snip>
>>
>>>>> +#ifndef CONFIG_ONENAND_IPL
>>>>> +     /* setting SRAM */
>>>>> +     ldr     r0, =S5PC100_SROMC_BASE
>>>>> +     ldr     r1, =0x9
>>>>> +     str     r1, [r0]
>>>>> +#endif
>>>> Where is CONFIG_ONENAND_IPL defined ?
>>>> If it is not being used, the #ifndef logic should be reduced.
>>> Kyungmin Park sent the patch that is supported onenand_ipl for s5pc1xx.
>>> but not yet applied onenand_ipl patch for s5pc1xx.
>>> When that patch is applied, we need these logic.
>>> If necessary, I'll delete these logic until apply the patch.
>>>
>> If the patch already exits, it would be better if it was in this
>> patchset.  Can we get the onenand_ipl patch ?
> 
> To support the s5pc1xx OneNAND IPL. It needs to refactor the current
> OneNAND IPL.
> 
> Now I refactor the OneNAND IPL code first and then I will send a
> OneNAND IPL codes for s5pc1xx.
> 
> I want to leave current patch as is. Since If we delete the OneNAND
> IPL codes. No one can refer the codes. I mean OneNAND IPL parts
> contains clock and memory configuration. These are helpful to someone
> who use NAND or NOR.
> 

Yes. Leaving this patch as-is is Ok.

Please refactor the old patch and include it as this patch's
dependant in the next revision of s5pc1xx patch set.

Tom


> Thank you,
> Kyungmin Park