[U-Boot] [PATCH 1/1] TI OMAP3 Use arm init sequence to initialize i2c

[Heiko Schocher <hs@denx.de>]

Hello Tom,

Tom Rix wrote:
> This changes fixes an early i2c error.
> 
> It appears that I2C is working because once a read or write
> error is detected, the omap24xx_i2c driver calls i2c_init
> inside its error handling check.
> 
> While it is ok to attempt error handling this way, the boards
> must not depend on this side effect to initialize it's i2c.
> 
> Instead of explicitly calling i2c_init for every board, use
> the generic arm initialization in lib_arm/board.c. By defining
> the config variable CONFIG_HARD_I2C, the omap3 i2c initialization
> is included in the init_sequence table.
> 
> Run tested on Beagle.
> Compile tested on the omap3's
> 
> Signed-off-by: Tom Rix <Tom.Rix@windriver.com>
> ---

Patch does not apply:

$ git am --whitespace=strip ../patches/20090928/\[U-Boot\]\ \[PATCH\ 1_1\]\ TI\ OMAP3\ Use\ arm\ init\ sequence\ to\ initialize\  i2c.eml
Applying: TI OMAP3 Use arm init sequence to initialize i2c
error: patch failed: include/configs/omap3_overo.h:114
error: include/configs/omap3_overo.h: patch does not apply
Patch failed at 0001.
When you have resolved this problem run "git am --resolved".
If you would prefer to skip this patch, instead run "git am --skip".
To restore the original branch and stop patching run "git am --abort".
$

please fix

thanks

bye
Heiko
-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany