From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Date: Wed, 11 Nov 2009 20:58:06 -0600 Subject: [U-Boot] [PATCH V5 0/4] add TI DA8xx support: In-Reply-To: <4AF98238.5030102@gefanuc.com> References: <4AF98238.5030102@gefanuc.com> Message-ID: <4AFB79BE.2090801@windriver.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Nick Thompson wrote: > Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board. > > See: > http://www.ti.com > http://www.spectrumdigital.com/ > > DA8xx is similar to DaVinci devices, but has a differing memory map and > updated peripherals. It is intended that DaVinci drivers will be modified in > some way to support these differences. > > A side effect of this is that there are some legacy code constructs in this > patch set that are required to utilize the DaVinci drivers as they stand now. > For example there are some volatiles and memory pointer types defined that are > no longer considered acceptable. > > The new code in this patch set doesn't use these constructs and the remaining > artefacts can be removed when the DaVinci drivers stop using them. > > This patch set is based on code originally from TI. > --- > Changes from previous patch set: > > #defines of constant variables to lower case > load registers only as required in clk_get() > > This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer > configuration API" posted on 2009-11-04 Yes it is dependent. There is a compile error without the pin mux function. Once the pin multiplex patch is ack-ed then Ack to this patch set. Thanks Tom > > Applies to u-boot-ti: > _______________________________________________ > U-Boot mailing list > U-Boot at lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot