[U-Boot] [PATCH v3] DA8xx: Add MUSB host support

[Tom <Tom.Rix@windriver.com>]

Gupta, Ajay Kumar wrote:
> Hi,
>> Hi,
>>> Tested USB host functionality on DA830 EVM.
>>>
>>> Signed-off-by: Ajay Kumar Gupta <ajay.gupta@ti.com>
>>> Signed-off-by: Swaminathan S <swami.iyer@ti.com>
>>> ---
>> <snip..>
>>
>>> --- a/include/usb.h
>>> +++ b/include/usb.h
>>> @@ -183,7 +183,8 @@ struct usb_device {
>>>  #if defined(CONFIG_USB_UHCI) || defined(CONFIG_USB_OHCI) || \
>>>       defined(CONFIG_USB_EHCI) || defined(CONFIG_USB_OHCI_NEW) || \
>>>       defined(CONFIG_USB_SL811HS) || defined(CONFIG_USB_ISP116X_HCD) || \
>>> -     defined(CONFIG_USB_R8A66597_HCD) || defined(CONFIG_USB_DAVINCI)
>>> +     defined(CONFIG_USB_R8A66597_HCD) || defined(CONFIG_USB_DAVINCI) || \
>>> +     defined(CONFIG_USB_DA8XX)
>>> These are aligned incorrectly (should be 4 spaces rather than a tab)
>> It was originally with tabs only. Are you suggesting to change all 5 lines to match the alignment ?
>>
>> Tom,
>> What do you think on this one?
> 
>> In general tabs are preferred but I would like to review the entire patchset.
>> When you make changes to a subset of the patches, you must repost the entire
>> patchset.
> 
>> Please repost the entire patchset.
> 
> Ok sure. Shall I post this patch with tabs or with 4-spaces as Nick suggested ?
> 

Just repost it as-is.

Please be aware that this is a USB change.
And though I can provide some input the ack/nak decision is Remy's.

Tom

> Regards,
> Ajay
> 
>> Tom
> 
> 
>> -Ajay
> 
>