[U-Boot] [PATCH V2 3/3] Add support for the LaCie ED Mini V2 board

[Albert ARIBAUD <albert.aribaud@free.fr>]

Wolfgang Denk a ?crit :
> Dear Albert Aribaud,
> 
> In message <1258239796-21528-4-git-send-email-albert.aribaud@free.fr> you wrote:
>> This board is based on the Marvell Orion5x SoC.
>> Current support is limited to console and Flash.
>> Flash support uses LEGACY as the Macronix 29LV400
>> used on ED Mini V2 is not 100% CFI compliant.
> 
> And the differences are really so big that we cannot tweak the CFI
> driver?

Apparently not.

The MX29LV400CB is 8-bit/16-bit and it configured on the ED Mini as 
8-bit, but presents a pure 16-bit QRY (with zeroes between qry bytes) 
which causes cfi_flash to mistakenly detect it as 16-bit wide, and thus 
use 16-bit accesses at 16-bit addresses to read IDs and write 
instructions, which of course does not work.

>> +int dram_init(void)
>> +{
>> +	int i;
>> +
>> +	for (i = 0; i < CONFIG_NR_DRAM_BANKS; i++) {
>> +		gd->bd->bi_dram[i].start = orion5x_sdram_bar(i);
>> +		gd->bd->bi_dram[i].size = orion5x_sdram_bs(i);
>> +	}
>> +	return 0;
>> +}
> 
> Cannot you use get_ram_size() for auto-sizing and checking?

As this is SoC code, not board code, and as the SoC allows to have up to 
four non-contiguous DRAM banks, I prefer to read the four DRAM base/size 
registers.

Amicalement,
-- 
Albert.