[U-Boot] [PATCH] imx51:Add support basic boot code of freescale imx51 bbg board

[Stefano Babic <sbabic@denx.de>]

Fred Fan wrote:
> Dear wolfgang,
>     I almost fixed all of your comments.

Hi Fred,

I have already tested your patch on the babbage2 board and I would ask
you about the status. The boot loader does not start  (I have tried
flashing the SPI NOR, and this seems ok. The code seems loaded from the
flash) but the board hangs. With the debugger seems that it hangs in the
init_clock assemby routine in lowlevel_init.S.

Have you seen the same behavior or do you think it depens on my
environment ?

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================