[U-Boot] TI:OMAP:[PATCH 4/7] Add support for 720Mhz

[Tom <Tom.Rix@windriver.com>]

Khasim Syed Mohammed wrote:
> From 977856ac122e451a8de195d9f22253196572157a Mon Sep 17 00:00:00 2001
> From: Syed Mohammed Khasim <khasim@ti.com>
> Date: Tue, 12 Jan 2010 16:32:42 +0530
> Subject: [PATCH] Add support for 720Mhz
> 
> A New API to allow setting M value to support 720Mhz
> 
> Signed-off-by: Syed Mohammed Khasim <khasim@ti.com>
> ---
>  cpu/arm_cortexa8/omap3/clock.c |   21 +++++++++++++++++++++
>  1 files changed, 21 insertions(+), 0 deletions(-)
> 
> diff --git a/cpu/arm_cortexa8/omap3/clock.c b/cpu/arm_cortexa8/omap3/clock.c
> index 174c453..d67517a 100644
> --- a/cpu/arm_cortexa8/omap3/clock.c
> +++ b/cpu/arm_cortexa8/omap3/clock.c
> @@ -402,3 +402,24 @@ void per_clocks_enable(void)
> 
>  	sdelay(1000);
>  }
> +
> +/*
> + * Configure PRCM registers to get 720 Mhz
> + *
> + * NOTE: N value doesn't change, only M gets affected
> + */
> +void prcm_config_720mhz(void)
> +{

Generalize this
Change the name prcm_config.
Possiblly pass in an enum for supported clk.

Setting the omap clk is not this simple.
It is dependent on at least the input frequency.
I do not see where this is checked here.
You should rethink how this is being done.

Move this to the beagle board dir.

Tom