From: Graeme Russ <graeme.russ@gmail.com>
To: u-boot@lists.denx.de
Subject: [U-Boot] [RFC][PATCH 00/21] [x86] 'Comming of Age'
Date: Sun, 28 Mar 2010 18:38:47 +1100 [thread overview]
Message-ID: <4BAF0787.1050204@gmail.com> (raw)
In-Reply-To: <OF6370A154.849DBD44-ONC12576F3.005652C9-C12576F3.0056DAA8@transmode.se>
Joakim Tjernlund wrote:
>
> Graeme Russ <graeme.russ@gmail.com> wrote on 2010/03/27 12:54:03:
>> Joakim Tjernlund wrote:
>>> I did a few months ago for MPC83xx and sent it to the list. There was some
>>> discussion but in the end it wasn't applied because it was too invasive.
>>> PPC is especially bad as it needs to relocate string literals too.
>>>
>> To implement full relocation, I simply need to add an additional parameter
>> to this function which provides the 'link versus load' offset which will
>> get applied to the 'load versus run' offset calculation
>
> Are we talking about the same thing? when you say "does not
> need to be loaded at TEXT_BASE" you need something like my LINK_OFF patch,
> otherwise I don't see how you can boot out of flash otherwise.
>
I realise now that we are not talking about the same thing. The x86 port
always relocates into (and runs from) RAM. Only a very small stub is run
from flash (SDRAM setup and sizing, copy to RAM, process relocation entries
etc). This stub can be made fully relocatable while running from Flash
(with a few tricks)
By adjusting all position dependent code after copying into RAM, LINK_OFF
is no longer needed
Graeme
next prev parent reply other threads:[~2010-03-28 7:38 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-03-25 11:22 [U-Boot] [RFC][PATCH 00/21] [x86] 'Comming of Age' Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 01/21] [x86] Add unaligned.h Graeme Russ
2010-03-25 17:45 ` Mike Frysinger
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 02/21] [x86] #ifdef out getenv_IPaddr() Graeme Russ
2010-03-25 11:45 ` Vipin Kumar
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 03/21] [x86] Fix MMCR Access Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 04/21] [x86] Add register dump to crash handlers Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 05/21] [x86] Fix do_go_exec() Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 06/21] [x86] Fix sc520 memory size reporting Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 07/21] [x86] Split sc520 memory sizing versus reporting Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 08/21] [x86] Add RAM bootstrap functionality Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 09/21] [x86] Move GDT to a safe location in RAM Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 10/21] [x86] Pass relocation offset into Global Data Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 11/21] [x86] Fix copying of Real-Mode code into RAM Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 12/21] [ns16550] Enable port-mapped access Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 13/21] [x86] Use CONFIG_SERIAL_MULTI Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 14/21] [x86] Provide weak PC/AT compatibility setup function Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 15/21] [x86] Fix support for booting bzImage Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 16/21] [sc520] Allow boards to override udelay Graeme Russ
2010-03-25 11:22 ` [U-Boot] [RFC][PATCH 17/21] [eNET] Fix Flash Write Graeme Russ
2010-03-25 11:23 ` [U-Boot] [RFC][PATCH 18/21] [eNET] Fix CONFIG_SYS_HZ to be 1000 Graeme Russ
2010-03-25 11:23 ` [U-Boot] [RFC][PATCH 19/21] [eNET] Add support for onboard RTL8100B (RTL8139) chips Graeme Russ
2010-04-05 5:32 ` Ben Warren
2010-04-05 22:21 ` Graeme Russ
2010-03-25 11:23 ` [U-Boot] [RFC][PATCH 20/21] [eNET] Add PC/AT compatibility setup function Graeme Russ
2010-03-25 11:23 ` [U-Boot] [RFC][PATCH 21/21] Use SC520 MMCR to reset eNET board Graeme Russ
2010-03-26 15:55 ` [U-Boot] [RFC][PATCH 00/21] [x86] 'Comming of Age' Peter Tyser
2010-03-27 4:33 ` Graeme Russ
2010-03-27 11:02 ` Joakim Tjernlund
2010-03-27 11:54 ` Graeme Russ
2010-03-27 15:48 ` Joakim Tjernlund
2010-03-28 7:38 ` Graeme Russ [this message]
2010-03-28 10:06 ` Joakim Tjernlund
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4BAF0787.1050204@gmail.com \
--to=graeme.russ@gmail.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox