[U-Boot] [PATCH 2/2 v2] net, fec_mxc: setup the mac address in the device registers

[Heiko Schocher <hs@denx.de>]

always setup mac address register with the contents in ethaddr.

This is not in line with u-boot design principle "not to
initalize not used devices", and maybe should go away,
if there is a solution for passing the mac address to arm
linux kernels.

Tested on the magnesium board.

Signed-off-by: Heiko Schocher <hs@denx.de>
---
- changes since v1 posted here:
  http://lists.denx.de/pipermail/u-boot/2010-March/069192.html

  - splitted in two patches as Wolfgang suggested

 drivers/net/fec_mxc.c |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index 98ff64b..6841208 100644
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -752,9 +752,10 @@ static int fec_probe(bd_t *bd)
 	if (!eth_getenv_enetaddr("ethaddr", ethaddr)) {	
 		if (fec_get_hwaddr(edev, ethaddr) == 0) {
 			printf("got MAC address from EEPROM: %pM\n", ethaddr);
-			memcpy(edev->enetaddr, ethaddr, 6);
 		}
 	}
+	memcpy(edev->enetaddr, ethaddr, 6);
+	fec_set_hwaddr(edev);

 	return 0;
 }
-- 
1.6.2.5

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany