[U-Boot] [PATCH 2/2 v2] net, kirkwood_egiga: setup the mac address in the device registers

[U-Boot] [PATCH 2/2 v2] net, kirkwood_egiga: setup the mac address in the device registers

[Heiko Schocher]

always setup mac address register with the contents in ethaddr.

This is not in line with u-boot design principle "not to
initalize not used devices", and maybe should go away,
if there is a solution for passing the mac address to arm
linux kernels.

Tested on the suen3 board.

Signed-off-by: Heiko Schocher <hs@denx.de>
---
- changes since v1 posted here:
  http://lists.denx.de/pipermail/u-boot/2010-March/069193.html

  - split in two patches as Wolfgang suggested

 drivers/net/kirkwood_egiga.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/net/kirkwood_egiga.c b/drivers/net/kirkwood_egiga.c
index f8e421c..d575400 100644
--- a/drivers/net/kirkwood_egiga.c
+++ b/drivers/net/kirkwood_egiga.c
@@ -687,6 +687,7 @@ int kirkwood_egiga_initialize(bd_t * bis)
 			dev->enetaddr[4] = get_random_hex();
 			dev->enetaddr[5] = get_random_hex();
 		}
+		port_uc_addr_set(dkwgbe->regs, dev->enetaddr);

 		dev->init = (void *)kwgbe_init;
 		dev->halt = (void *)kwgbe_halt;
-- 
1.6.2.5

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany