[U-Boot] [PATCH] arm: add initilisation of watchdog in init_sequence

[Tom Rix <tom@bumblecow.com>]

Nicolas Ferre wrote:
> For platforms that implement a hardware watchdog, call its initialization
> routine in init_sequence.
> This location has been chosen to be the closest to initialization of console as
> some watchdog drivers are writing status messages. On the other hand, watchdog
> setup should be close to chip startup to be able to begin the triggering
> quickly.
> 
I am not opposed to putting watchdog into the init sequence.

A current ARM way for initializing the watchdog is to do it in
s_init.  Why doesn't this work for you ?

Reviewing other watchdog additions in the init sequences from powerpc,sh,m68k
If an init is to be added, this setup should be cut-n-pasted from one
of these.  There should be follow-on patches to convert the ARM s_init's over to 
using the init sequence.

Tom


> Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
> ---
>  arch/arm/lib/board.c |    7 +++++++
>  1 files changed, 7 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/lib/board.c b/arch/arm/lib/board.c
> index f5660a9..569009e 100644
> --- a/arch/arm/lib/board.c
> +++ b/arch/arm/lib/board.c
> @@ -70,6 +70,10 @@ extern int  AT91F_DataflashInit(void);
>  extern void dataflash_print_info(void);
>  #endif
>  
> +#ifdef CONFIG_HW_WATCHDOG
> +extern void hw_watchdog_init(void);
> +#endif
> +
>  #ifndef CONFIG_IDENT_STRING
>  #define CONFIG_IDENT_STRING ""
>  #endif
> @@ -251,6 +255,9 @@ init_fnc_t *init_sequence[] = {
>  	serial_init,		/* serial communications setup */
>  	console_init_f,		/* stage 1 init of console */
>  	display_banner,		/* say that we are here */
> +#if defined(CONFIG_HW_WATCHDOG)
> +	hw_watchdog_init,	/* watchdog setup */
> +#endif
>  #if defined(CONFIG_DISPLAY_CPUINFO)
>  	print_cpuinfo,		/* display cpu info (and speed) */
>  #endif