[U-Boot] [PATCH v3 00/19] SPEAr : Network support for spear platforms and SPEAr1300

[Vipin KUMAR <vipin.kumar@st.com>]

Dear Tom, Wolfgang,

Can you please let me know the status of the remainging patches of this patch-set.
I have not received any reply after sending v3 patch a long time back

These are the Acks I have already received

SPEAr : Configuring FSMC driver for NAND interface
http://www.mail-archive.com/u-boot at lists.denx.de/msg31656.html
SPEAr : FSMC driver support added
http://www.mail-archive.com/u-boot at lists.denx.de/msg31655.html
SPEAr : i2c driver moved completely into drivers/i2c
http://www.mail-archive.com/u-boot at lists.denx.de/msg31604.html
SPEAr : USB Device Controller driver support added
http://www.mail-archive.com/u-boot at lists.denx.de/msg32362.html
SPEAr : macb driver support added for spear310 and spear320
http://www.mail-archive.com/u-boot at lists.denx.de/msg33153.html
SPEAr : Network support configured for spear SoCs
http://www.mail-archive.com/u-boot at lists.denx.de/msg33152.html

Thanks in advance

Regards
Vipin

On 5/28/2010 10:22 PM, Vipin Kumar wrote:
> Dear Wolfgang,
> 
> This patch-set as been pending for a long time and it seems Tom is also away
> from mails. A few patches have already been Acked by respective device owners
> 
> Please let me know how do I get this patch-set included in 2006.06 release
> 
> Thanks in advance
> Vipin
> 
> On Fri, May 14, 2010 at 8:26 AM, Vipin KUMAR <vipin.kumar@st.com> wrote:
>> Dear Tom,
>>
>> I am still waiting for Ack/feedback if any on this patchset v3
>> All feedbacks provided by you on patchset v2 have been incorporated
>>
>> Regards
>> Vipin
>>
>> On 5/9/2010 7:46 PM, Vipin Kumar wrote:
>>> Hello Tom,
>>>
>>> Please consider this patch-set for mainline submission.
>>> Please let me know if there are any changes to be made
>>> in code or if the patches are good to go into mainline
>>>
>>> Thanks & Regards
>>> Vipin
>>>
>>> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.kumar@st.com> wrote:
>>>> Hello Tom,
>>>>   The following patch-set contains all the accepted feedbacks on patch-set v2.
>>>>   Please consider this for submission into mainline
>>>>
>>>>   Below changes are introduced other than the recieved review comments
>>>>   1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
>>>>   the ethernet phy address. Searching was always enabled in earlier patch
>>>>   2. Introduced a new function dw_write_hwaddr in ethernet driver and
>>>>   registered it as a callback via dev->write_hwaddr. This is a new feature
>>>>   recently implemented by Ben.
>>>>
>>>> Thanks in advance
>>>>
>>>> Regards
>>>> Vipin
>>>>
>>>> Vipin Kumar (19):
>>>>  u-boot.img file not created when srctree and objtree are different
>>>>  change_bit routine defined
>>>>  SPEAr : SMI erase and write timeouts increased
>>>>  SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>>>>  SPEAr : Reducing the max RAM size to 128MB
>>>>  SPEAr : Basic arch related support added for SPEAr SoCs
>>>>  SPEAr : Network driver support added
>>>>  SPEAr : Network support configured for spear SoCs
>>>>  SPEAr : macb driver support added for spear310 and spear320
>>>>  SPEAr : FSMC driver support added
>>>>  SPEAr : Configuring FSMC driver for NAND interface
>>>>  SPEAr : i2c driver moved completely into drivers/i2c
>>>>  SPEAr : smi driver moved completely into drivers/mtd
>>>>  SPEAr : USB Device Controller driver support added
>>>>  SPEAr : Supporting various configurations for spear3xx and spear6xx
>>>>    boards
>>>>  SPEAr : Basic spear1300 architecture support added
>>>>  SPEAr : spear1300 SoC support added
>>>>  SPEAr : Removing extraneous code
>>>>  SPEAr : USB device controller bugfixes
>>>>
>>>>  MAINTAINERS                                        |    1 +
>>>>  MAKEALL                                            |    1 +
>>>>  Makefile                                           |   30 +-
>>>>  arch/arm/cpu/arm926ejs/spear/Makefile              |    3 +-
>>>>  arch/arm/cpu/arm926ejs/spear/cpu.c                 |   78 +++
>>>>  arch/arm/cpu/arm_cortexa8/spear13xx/Makefile       |   52 ++
>>>>  arch/arm/cpu/arm_cortexa8/spear13xx/cache.S        |  114 +++++
>>>>  arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c          |   96 ++++
>>>>  .../arm_cortexa8/spear13xx/reset.c}                |   52 +--
>>>>  arch/arm/cpu/arm_cortexa8/spear13xx/timer.c        |  138 +++++
>>>>  .../arm/include/asm/arch-spear/clk.h               |   26 +-
>>>>  arch/arm/include/asm/arch-spear/hardware.h         |   16 +-
>>>>  arch/arm/include/asm/arch-spear/spr_misc.h         |    5 +
>>>>  .../arm/include/asm/arch-spear13xx/hardware.h      |   33 +-
>>>>  arch/arm/include/asm/arch-spear13xx/spr_gpt.h      |   85 ++++
>>>>  arch/arm/include/asm/arch-spear13xx/spr_misc.h     |  317 ++++++++++++
>>>>  .../arm/include/asm/arch-spear13xx/sys_proto.h     |   29 +-
>>>>  arch/arm/include/asm/bitops.h                      |   11 +-
>>>>  board/spear/common/Makefile                        |   10 +-
>>>>  board/spear/common/spr_misc.c                      |   28 +-
>>>>  board/spear/spear1300/Makefile                     |   51 ++
>>>>  board/spear/spear1300/config.mk                    |   28 +
>>>>  board/spear/spear1300/spear1300.c                  |   88 ++++
>>>>  .../spear/spear1300/spr_lowlevel_init.S            |   35 +-
>>>>  board/spear/spear300/config.mk                     |   11 -
>>>>  board/spear/spear300/spear300.c                    |   15 +-
>>>>  board/spear/spear310/config.mk                     |   11 -
>>>>  board/spear/spear310/spear310.c                    |   36 ++-
>>>>  board/spear/spear320/config.mk                     |   11 -
>>>>  board/spear/spear320/spear320.c                    |   23 +-
>>>>  board/spear/spear600/config.mk                     |   11 -
>>>>  board/spear/spear600/spear600.c                    |   15 +-
>>>>  doc/README.designware_eth                          |   25 +
>>>>  doc/README.spear                                   |   46 ++-
>>>>  drivers/i2c/Makefile                               |    2 +-
>>>>  drivers/i2c/{spr_i2c.c => designware_i2c.c}        |    4 +-
>>>>  .../spr_i2c.h => drivers/i2c/designware_i2c.h      |    6 +-
>>>>  drivers/mtd/Makefile                               |    2 +-
>>>>  drivers/mtd/nand/Makefile                          |    2 +-
>>>>  drivers/mtd/nand/fsmc_nand.c                       |  366 ++++++++++++++
>>>>  drivers/mtd/nand/spr_nand.c                        |  124 -----
>>>>  drivers/mtd/{spr_smi.c => st_smi.c}                |   59 ++-
>>>>  .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h   |    8 +-
>>>>  drivers/net/Makefile                               |    1 +
>>>>  drivers/net/designware.c                           |  531 ++++++++++++++++++++
>>>>  drivers/net/designware.h                           |  264 ++++++++++
>>>>  drivers/serial/usbtty.h                            |    4 +-
>>>>  drivers/usb/gadget/Makefile                        |    2 +-
>>>>  drivers/usb/gadget/{spr_udc.c => designware_udc.c} |  116 +++--
>>>>  include/configs/spear-common.h                     |   33 +-
>>>>  include/configs/spear13xx_evb.h                    |  202 ++++++++
>>>>  include/configs/{spear3xx.h => spear3xx_evb.h}     |   30 ++
>>>>  include/configs/{spear6xx.h => spear6xx_evb.h}     |   13 +
>>>>  include/linux/mtd/fsmc_nand.h                      |  104 ++++
>>>>  include/netdev.h                                   |    1 +
>>>>  include/usb/{spr_udc.h => designware_udc.h}        |    6 +-
>>>>  56 files changed, 2993 insertions(+), 418 deletions(-)
>>>>  create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>>>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>>>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>>>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>>>>  rename arch/arm/{include/asm/arch-spear/spr_nand.h => cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>>>>  mode change 100644 => 100755
>>>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>>>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h (64%)
>>>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>>>>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>>>>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>>>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>>>>  create mode 100644 board/spear/spear1300/Makefile
>>>>  create mode 100644 board/spear/spear1300/config.mk
>>>>  create mode 100644 board/spear/spear1300/spear1300.c
>>>>  copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S (56%)
>>>>  create mode 100644 doc/README.designware_eth
>>>>  rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>>>>  rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
>>>>  create mode 100644 drivers/mtd/nand/fsmc_nand.c
>>>>  delete mode 100644 drivers/mtd/nand/spr_nand.c
>>>>  rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>>>>  rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h (96%)
>>>>  create mode 100644 drivers/net/designware.c
>>>>  create mode 100644 drivers/net/designware.h
>>>>  rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>>>>  create mode 100644 include/configs/spear13xx_evb.h
>>>>  rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>>>>  rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>>>>  create mode 100644 include/linux/mtd/fsmc_nand.h
>>>>  rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>>>>
>>>> _______________________________________________
>>>> U-Boot mailing list
>>>> U-Boot at lists.denx.de
>>>> http://lists.denx.de/mailman/listinfo/u-boot
>>>>
>>>
>>
>>
>