[U-Boot] [PATCH 1/2] cpuat91: unbreak ethernet

[Ben Warren <biggerbadderben@gmail.com>]

Hi Eric,

On 6/10/2010 2:50 PM, Eric B?nard wrote:
> * the following problems are met :
> config was set to use the new driver as a default but
> - RMII was not enabled for the new driver
> - the new driver didn't compile with RMII enabled
> - the new driver initialize a PHY at address O when the PHY of
> this board is at 1 thus we get "AT91 EMAC RMII: No PHY present"
>
> * to fix these problems, this patch :
> - enable RMII for the new driver
> - fix the wrong define used in the at91_emac.c
> - allow the config file to set a default phy address (and use
> 0 as a default as in the actual at91_emac.c driver)
>
> Signed-off-by: Eric B?nard<eric@eukrea.com>
> ---
>   drivers/net/at91_emac.c   |   24 ++++++++++++++----------
>   include/configs/cpuat91.h |    9 +++------
>   2 files changed, 17 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/net/at91_emac.c b/drivers/net/at91_emac.c
> index 2399569..1ebcf05 100644
> --- a/drivers/net/at91_emac.c
> +++ b/drivers/net/at91_emac.c
> @@ -53,6 +53,10 @@
>   	Please decrease the CONFIG_SYS_RX_ETH_BUFFER value
>   #endif
>
> +#ifndef CONFIG_DRIVER_AT91EMAC_PHYADDR
> +#define CONFIG_DRIVER_AT91EMAC_PHYADDR	0
> +#endif
> +
>   /* MDIO clock must not exceed 2.5 MHz, so enable MCK divider */
>   #if (AT91C_MASTER_CLOCK>  80000000)
>   	#define HCLK_DIV	AT91_EMAC_CFG_MCLK_64
> @@ -198,12 +202,12 @@ static int at91emac_phy_reset(struct eth_device *netdev)
>   	emac = (at91_emac_t *) netdev->iobase;
>
>   	adv = ADVERTISE_CSMA | ADVERTISE_ALL;
> -	at91emac_write(emac, 0, MII_ADVERTISE, adv);
> +	at91emac_write(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_ADVERTISE, adv);
>   	VERBOSEP("%s: Starting autonegotiation...\n", netdev->name);
> -	at91emac_write(emac, 0, MII_BMCR, (BMCR_ANENABLE | BMCR_ANRESTART));
> +	at91emac_write(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_BMCR, (BMCR_ANENABLE | BMCR_ANRESTART));
>    
This line's too long.  Please check the other ones too.  Try to keep 
less than 78 characters.
>
>   	for (i = 0; i<  100000 / 100; i++) {
> -		at91emac_read(emac, 0, MII_BMSR,&status);
> +		at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_BMSR,&status);
>   		if (status&  BMSR_ANEGCOMPLETE)
>   			break;
>   		udelay(100);
> @@ -229,13 +233,13 @@ static int at91emac_phy_init(struct eth_device *netdev)
>   	emac = (at91_emac_t *) netdev->iobase;
>
>   	/* Check if the PHY is up to snuff... */
> -	at91emac_read(emac, 0, MII_PHYSID1,&phy_id);
> +	at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_PHYSID1,&phy_id);
>   	if (phy_id == 0xffff) {
>   		printf("%s: No PHY present\n", netdev->name);
>   		return 1;
>   	}
>
> -	at91emac_read(emac, 0, MII_BMSR,&status);
> +	at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_BMSR,&status);
>
>   	if (!(status&  BMSR_LSTATUS)) {
>   		/* Try to re-negotiate if we don't have link already. */
> @@ -243,7 +247,7 @@ static int at91emac_phy_init(struct eth_device *netdev)
>   			return 2;
>
>   		for (i = 0; i<  100000 / 100; i++) {
> -			at91emac_read(emac, 0, MII_BMSR,&status);
> +			at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_BMSR,&status);
>   			if (status&  BMSR_LSTATUS)
>   				break;
>   			udelay(100);
> @@ -253,8 +257,8 @@ static int at91emac_phy_init(struct eth_device *netdev)
>   		VERBOSEP("%s: link down\n", netdev->name);
>   		return 3;
>   	} else {
> -		at91emac_read(emac, 0, MII_ADVERTISE,&adv);
> -		at91emac_read(emac, 0, MII_LPA,&lpa);
> +		at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_ADVERTISE,&adv);
> +		at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_LPA,&lpa);
>   		media = mii_nway_result(lpa&  adv);
>   		speed = (media&  (ADVERTISE_100FULL | ADVERTISE_100HALF)
>   			 ? 1 : 0);
> @@ -271,7 +275,7 @@ int at91emac_UpdateLinkSpeed(at91_emac_t *emac)
>   {
>   	unsigned short stat1;
>
> -	at91emac_read(emac, 0, MII_BMSR,&stat1);
> +	at91emac_read(emac, CONFIG_DRIVER_AT91EMAC_PHYADDR, MII_BMSR,&stat1);
>
>   	if (!(stat1&  BMSR_LSTATUS))	/* link status up? */
>   		return 1;
> @@ -372,7 +376,7 @@ static int at91emac_init(struct eth_device *netdev, bd_t *bd)
>   	value = AT91_EMAC_CFG_CAF |	AT91_EMAC_CFG_NBC |
>   		HCLK_DIV;
>   #ifdef CONFIG_RMII
> -	value |= AT91C_EMAC_RMII;
> +	value |= AT91_EMAC_CFG_RMII;
>   #endif
>   	writel(value,&emac->cfg);
>
> diff --git a/include/configs/cpuat91.h b/include/configs/cpuat91.h
> index b4fda76..049298c 100644
> --- a/include/configs/cpuat91.h
> +++ b/include/configs/cpuat91.h
> @@ -131,15 +131,12 @@
>   	(CONFIG_SYS_MEMTEST_START + PHYS_SDRAM_SIZE - 512 * 1024)
>
>   #define CONFIG_NET_MULTI		1
> -#ifdef CONFIG_NET_MULTI
>   #define CONFIG_DRIVER_AT91EMAC		1
>   #define CONFIG_SYS_RX_ETH_BUFFER	8
> -#else
> -#define CONFIG_DRIVER_ETHER		1
> -#endif
> +#define CONFIG_RMII			1
> +#define CONFIG_MII			1
> +#define CONFIG_DRIVER_AT91EMAC_PHYADDR	1
>   #define CONFIG_NET_RETRY_COUNT			20
> -#define CONFIG_AT91C_USE_RMII			1
> -#define CONFIG_PHY_ADDRESS			(1<<  5)
>   #define CONFIG_KS8721_PHY			1
>
>   #define CONFIG_SYS_FLASH_CFI			1
>    
regards,
Ben