[U-Boot] [PATCH] orion5x: edminiv2: add libata support

[Albert ARIBAUD <albert.aribaud@free.fr>]

Le 01/07/2010 10:41, Prafulla Wadaskar a ?crit :
>
>
>> -----Original Message-----
>> From: u-boot-bounces at lists.denx.de
>> [mailto:u-boot-bounces at lists.denx.de] On Behalf Of Tor Krill
>> Sent: Thursday, July 01, 2010 1:07 PM
>> To: Albert Aribaud
>> Cc: u-boot at lists.denx.de
>> Subject: Re: [U-Boot] [PATCH] orion5x: edminiv2: add libata support
>>
>> On Wed, 2010-06-30 at 23:30 +0200, Albert Aribaud wrote:
>>> Signed-off-by: Albert Aribaud<albert.aribaud@free.fr>
>>> ---
>>> This patch:
>>> - adds support in libata for the orion5x MVSATAHC controller;
>>> - enables orion5x MVSTAHC port 1 on the edmini board;
>>> - adds IDE and EXT2 commands to the edminiv2 command set.
>>
>> Just a heads up. I posted a patch with a sata-driver for kirkwood a
>> while back. (We use this with our board and it seems to work fine)
>>
>> http://lists.denx.de/pipermail/u-boot/2010-June/073147.html
>
> I was just trying to test it, May I know relevant board configs?
>
>>
>> Which might have some similarities to the sata controller on orion.
>
> like egiga, we can think of having single sata driver for this.

I'm not against looking into integrating the sata-mv driver for orion5x 
as a SoC; but I'll retain the IDE approach at least for the ED Mini 
where NOR Flash space might be scarce and disk DMA at bootloader stage 
isn't a must IMO.

Regarding egiga sharing between kirkwood and orion5x, I have recently 
submitted a set of patches to the list with a request for comments.

> Regards..
> Prafulla . .

Amicalement,
-- 
Albert.