[U-Boot] [PATCH v2] net: Add option to disable fiber on M88E1111 PHY for PPC4xx

[Ben Warren <biggerbadderben@gmail.com>]

  Hi Stefen,

On 6/29/2010 12:23 AM, Stefan Roese wrote:
> By defining CONFIG_M88E1111_DISABLE_FIBER boards can configure the
> M88E1111 PYH to disable fiber. This is needed for an upcoming PPC460GT
> based board, which has fiber/copper auto-selection enabled by default.
> This doesn't seem to work. So we disable fiber in the PHY register.
>
> Signed-off-by: Stefan Roese<sr@denx.de>
> Cc: Ben Warren<biggerbadderben@gmail.com>
> ---
> v2: - Fixed spelling: fibre ->  fiber
>
>   drivers/net/4xx_enet.c |    5 +++++
>   1 files changed, 5 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/net/4xx_enet.c b/drivers/net/4xx_enet.c
> index 2fac641..144b851 100644
> --- a/drivers/net/4xx_enet.c
> +++ b/drivers/net/4xx_enet.c
> @@ -1095,6 +1095,11 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis)
>   		miiphy_write (dev->name, reg, 0x18, 0x4101);
>   		miiphy_write (dev->name, reg, 0x09, 0x0e00);
>   		miiphy_write (dev->name, reg, 0x04, 0x01e1);
> +#if defined(CONFIG_M88E1111_DISABLE_FIBER)
> +		miiphy_read(dev->name, reg, 0x1b,&reg_short);
> +		reg_short |= 0x8000;
> +		miiphy_write(dev->name, reg, 0x1b, reg_short);
> +#endif
>   #endif
>   #if defined(CONFIG_M88E1112_PHY)
>   		if (bis->bi_phymode[devnum] == BI_PHYMODE_SGMII) {
Applied to net repo.

thanks,
Ben