[U-Boot] mkconfig "arch" link generation

[Stefano Babic <sbabic@denx.de>]

Matteo Facchinetti wrote:
> Hi,
> 

Hi Matteo,

> I'm updating my uboot to mainline and I have a question about a link 
> generate from mkconfig (with mpc5121_config).
> Follwing link in "include/asm", I found a link named "arch" genarated by 
> mkconfig.
> This is broken so point to "arch-mpc512x" instead of 
> "arch/powerpc/cpu/mpc512x".

Yes, the link is broken. However, all boards in the mainline using the
MPC512x are compiled clean. This is because asm-offsets.h is included
only by arch/powerpc/cpu/mpc512x/start.S with "#include "asm-offsets.h",
and the compiler search for the file in the same directory of start.S
and can find it.
The link is not required to compile the 512x boards supported currently
by u-boot, but it must be set for the ARM architecture. Under the
kernel, asm-offsets.h is auto-generated (I know, this is the best solution).

However, why do you need this file ? It should be required only by low
level initialization in assembly, as it is done by start.S. After that,
it is required in u-boot to access to registers/peripherals via C
structures and not using offsets.

> Result is "#include <asm/arch/asm-offsets.h>" or similar are be broken.
> 
> How is the correct way to modify mkconfig?

Probably not setting the link for powerpc, because it is not required.

Regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================