[U-Boot] [PATCH] Use common function to set GPIOs for MX3 and MX5

[Stefano Babic <sbabic@denx.de>]

David Jander wrote:

> Great. I'll wait.
> In the meantime I have just done this to get it working:
> 
> #ifdef CONFIG_MX31
> void spi_cs_activate(struct spi_slave *slave)
> {
> 	struct mxc_spi_slave *mxcs = to_mxc_spi_slave(slave);
> 	if (mxcs->gpio > 0)
> 		mxc_gpio_set(mxcs->gpio, mxcs->ctrl_reg & MXC_CSPICTRL_SSPOL);
> }
> 

Ok, but one goal I have is to get rid of nasty #ifdef CONFIG_MX*. I
introduce general gpio functions to make code more common, and I do not
want to fall back adding processor switches.

> Seems to work, but never mind...

Ok, I will resend my patch, I hope you can give a chance a test it on
your target.

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================