[U-Boot] [PATCH] Use common function to set GPIOs for MX3 and MX5

[Stefano Babic <sbabic@denx.de>]

David Jander wrote:
> Ok, I guess I was pessimistic. There is a weird bug in mxc_spi.c: CPOL is 
> negated!
> I just saw that in the mx51evk.h header file CONFIG_FSL_PMIC_MODE was set to 
> low-active clock (CPOL=1), which is not supposed to work. But it did work, and 
> on the scope clock-polarity was active-high.

Ok

> 
> In spi_cfg(), I saw this line:
> 
> if (!(mode & SPI_CPOL))
> 	sclkpol = 1;
> 
> AFAIK, this should be:
> 
> if (mode & SPI_CPOL)
> 	sclkpol = 1;
> 
> At least for the MX51. Can you confirm that this is different on the MX31?

Agree. According to the MX51 Manual, the register must be set with:
	0 Active high polarity (0 = Idle).
	1 Active low polarity (1 = Idle).

So we need to change both CONFIG_FSL_PMIC_MODE in config and in
mxc_spi.c. Do you send a patch or do you prefer I will do this job ? I
will add your signed-off-by if you agree.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================